How to solve the blockage when the granite crusher is working

　　When the crusher crushes granite, coal gangue, shale, coal slag, slag, construction waste and other materials, the phenomenon of blockage may occur. What is the cause? When crushing granite and other materials, the material cannot enter the silo due to the problems of the equipment itself or human reasons, and the phenomenon of blockage occurs. Let me share with you the reasons that may cause the equipment to block and the solutions.

　　1. Whether the feed amount is too large. There is an upper limit on the amount of materials that the crushing equipment can withstand. If the granite and other materials entering the equipment are too fast, the accumulated materials will increase, and the load of the crusher will increase, resulting in blockage. Solution: control the feeding method; you can limit the amount of material entering the equipment by adding a feeder, so as to better control the feeding amount and reduce the phenomenon of clogging, and there are two kinds of feeders, one is manual , One is automatic, which should be selected according to the actual situation of the customer. At the same time, we should also pay attention to the working current of the crusher is generally controlled at about 85%.

　　2. Whether the discharge pipeline is normal. If it is not smooth, it will also lead to the blockage of the crusher. Carefully check whether the air in the discharge pipeline is weakened or there is no air. If it is blocked, you can clean the feed opening or replace the conveying equipment, and you can also control the amount of feed to reduce the phenomenon of blockage. .

　　3. Whether the crushing equipment is in good working condition. Regular maintenance of equipment to avoid component aging and improve equipment reliability can not only improve the production efficiency of the equipment, but also reduce the occurrence of blockages.