Analysis of the reasons why the cone crusher does not meet the standard

　　If in the production process of the cone crusher, many problems occur due to various reasons, such as unreasonable discharge, material jamming, etc., then the production efficiency will be *ly reduced, which will make the production of cone crusher equipment. The output gradually decreases, which means that the output of the cone crusher equipment is not up to standard, so the user's economic benefits will lose a large part. Therefore, we should pay attention to the problem that the material does not meet the standard, and we must * know what caused it.

1. Broken ratio

　　The crushing ratio refers to the ratio of the imported material and the particle size of the crushed finished product. The larger the ratio, the larger the crushing ratio, and vice versa. For the production process of the cone crusher equipment, if the crushing ratio is large, the needle flake content Therefore, in production, the adjustment of the crushing ratio is an important measure to ensure the discharge. Of course, the crushing ratio is too small. Therefore, the selection of the crushing ratio needs to be appropriate.

　　2. Different types or models can process different feed sizes. If the feed size is not suitable, it will also cause the phenomenon that the output quality is not up to standard. For example, when the feed size is reduced from 100mm to 50mm At the same time, the needle flake content in the finished material decreased by 38%, so the feeding particle size must meet the requirements of the production equipment.

　　3. Cyclic load

　　The working process of the cone crusher equipment is carried out in a closed-circuit cycle. If the discharge opening is increased, the load in the cycle will be increased, and the shape of the stone will become better. During the whole process, due to the increase in the cycle load, each equipment in the system However, when the discharge port is enlarged, the load of the main crushing motor can be reduced, and the shape of the finished material is better. Therefore, it is very important to adjust the cyclic load in production.

　　4. Open circuit and closed circuit circulation

　　In the production of cone crusher equipment, the circulation is divided into circuit circulation and closed circuit circulation. The former is called sieving * and then crushing, the latter is called * crushing and then sieving. The finished product is screened and then enters the secondary crushing feed port for crushing, so that the output of the finished material increases, and the needle flake content also increases. After re-breaking, it enters the finished product screen for screening. The whole system is a closed system. There is no loss of crushed material, the cycle load is large, but the product shape is good. In the actual production of cone crusher equipment, open-circuit or closed-circuit circulation can be selected according to the needs of production.

　　The failure of the cone crusher equipment to discharge is mainly caused by the above four reasons. Therefore, when we use the cone crusher equipment to work, we must carry out daily inspections and carefully check whether the cone crusher equipment itself is faulty. Solution; Secondly, it is necessary to check the surrounding environment one by one, and try to deal with the factors that affect the production effect of the cone crusher equipment. When the cone crusher equipment is used, it must be cleaned, and do not let the remaining materials exist inside the cone crusher equipment.