What needs to be adjusted in the daily work of the stone sand making machine

　　The stone crusher sand making machine is an easy-to-use and very practical machine for crushing stones into sand. When processing materials, the stone crushing sand making machine can be adjusted according to the user's needs, such as feeding speed, feeding method, discharging, etc. But in the adjustment of the equipment, some matters need our more attention.

1. Feeding speed

　　Adjust the speed of the feeding motor to increase or decrease the feeding amount. High rotation speed, large feeding amount, and increased load of crushing motor. If the speed of the impeller of the stone crusher sand making machine is not increased much at this time, the material accumulation in the crushing cavity of the main machine will increase, the output will not be improved, the fineness will become uneven, the energy consumption will increase, and the body temperature of the sand making machine will increase. If it rises, the wear-resistant parts will be worn unnecessarily, and it will even cause material blockage.

　　2. Feeding method adjustment

　　In fact, the feeding adjustment can also be attributed to the feeding speed. The points that need to be paid attention to are roughly the same. What you need to understand is that there are two feeding methods for the stone crusher sand making machine, namely full center feeding and waterfall and center feeding. material. The output brought by different feeding methods is different. The output of the latter is about twice as high as that of the former. Of course, the required power and energy consumption will also increase. When increasing the feed, pay attention to adjusting the impeller speed.

　　3. Discharge adjustment

　　Adjust the fineness of the finished product as needed. The impeller speed is inversely proportional to the particle size of the product, and also inversely proportional to the output. The higher the rotational speed, the finer the product and the lower the output. Adjusting the speed of the impeller will adjust the output and the fineness of the finished product.